|
|
Post by niagaracncww on Nov 26, 2018 14:13:14 GMT -5
hello my lazer attachment will turn on manually but not when running a program .... i have triple checked wiring of the lazer and it is good to go when i turn to manual mode the lazer come on as it should so i know the lazer is ok. seems more of a communication between the machine and lazer when running the program any suggestions?? on what do do the post has worked before and nothing has changed other then getting the lazer replaced from it being faulty?
thanks for any help
|
|
|
|
Post by uzumati on Nov 27, 2018 8:36:21 GMT -5
Have you checked to make sure the mode switch wasn’t accidentally moved?
MODE SELECTOR SWITCH
The driver board has a selector switch for the two different modes of the board.
Input Control Mode: This is when the switch is on the RIGHT. This mode allows for a signal to be connected to connectors H2 or H4 for a signal to turn the laser on and off. Use this input with your controller to turn the laser on and off with G Code commands.
CW Mode: This is when the switch is on the LEFT. This mode stands for "Constant Wave", which means that the laser will turn on and stay on until the switch is turned back to the right or the power on the board is turned off.
|
|
