|
Post by gerry on Nov 14, 2018 1:40:23 GMT -5
The machined should be homed every time it is started.
|
|
|
Post by stevem on Nov 14, 2018 10:04:12 GMT -5
Please try describing the problem in more detail so we can help you!
|
|
|
Post by noland on Nov 16, 2018 17:18:09 GMT -5
I had a similar problem. It would hang in a certain spot every time. So i put it in that spot and loosened the ball nut on the x axis. Ran the x back and forth 1 time and stopped it on the bad spot again. Then re tightened the 4 screws on the ball nut and everything was fine after that. Oh, and make sure you clean and oil your rails and ball screw.
|
|