Don't have access to full X axis

[keithf]

On my Pro 6, I cut out a 23inch circle with no problem.  I then ran a 22inch circle and i had to "stop" to get a clamp out of the way.  (my bad)  I must have hit a wrong key, because when i restarts the job, it says the "X+ is out of limits". When i manually move i to right , it just stops about 4 inch from the edge. I am guessing that i set a soft ware limit somehow? I can't find anything in manual or on line that addresses this. Anybody know how to fix.  I just read what i wrote, maybe i should turn it off (reboot) and see what happens?

[stevem]

When you get an out of limit message, it's telling you it can't make the cut on that axis.
I would try starting the cut from the beginning.

[gerry]

You may have reset the origin. Try re-homing the machine.