|
Post by keithf on Apr 23, 2018 19:51:36 GMT -5
On my Pro 6, I cut out a 23inch circle with no problem. I then ran a 22inch circle and i had to "stop" to get a clamp out of the way. (my bad) I must have hit a wrong key, because when i restarts the job, it says the "X+ is out of limits". When i manually move i to right , it just stops about 4 inch from the edge. I am guessing that i set a soft ware limit somehow? I can't find anything in manual or on line that addresses this. Anybody know how to fix. I just read what i wrote, maybe i should turn it off (reboot) and see what happens?
|
|
|
Post by stevem on Apr 23, 2018 21:54:53 GMT -5
When you get an out of limit message, it's telling you it can't make the cut on that axis. I would try starting the cut from the beginning.
|
|
|
Post by gerry on Apr 23, 2018 23:15:35 GMT -5
You may have reset the origin. Try re-homing the machine.
|
|