|
|
Post by hellorogerthat on Mar 16, 2018 13:57:10 GMT -5
My AR8 has been off for 4 months or so. When I started it up and entered "All Access Home" it went to the near left corner of the machine and didn't stop. Seems the controller has lost it's data maybe. Should I be re-installing the controller backup file and where do I get it? Is there a firmware update?
|
|
|
|
Post by BigMoose on Mar 16, 2018 14:03:11 GMT -5
My first guess would be a limit switch went bad. That is what tells the CNC where to stop so I would start there. I am not sure how to test them but you could probably find out somewhere.
|
|
|
|
Post by hellorogerthat on Mar 16, 2018 14:04:48 GMT -5
Thanks. I was just looking at that to see how dusty they might be but they look visually good.
|
|
|
|
Post by hellorogerthat on Mar 16, 2018 14:11:14 GMT -5
Actually, none of the limit switches are working. It must be in the controller. I need to get the backup file and re-intall the data.
|
|
|
|
Post by BigMoose on Mar 16, 2018 15:55:33 GMT -5
Email support@axiomtoolgroup.com and explain it to them and Chad will get back to you. Coming up on the weekend it might take a bit but they are pretty good about replying fairly quickly.
|
|
|
|
Post by hellorogerthat on Mar 16, 2018 16:18:32 GMT -5
Thanks. I did. They are always great.
|
|
|
|
Post by jigsaw on Jun 5, 2018 22:00:21 GMT -5
Did you find the problem? I found that if I turn mine on and do not wait long enough for it to completely boot up before I press the all home it does not stop. If I wait a little longer so far it seams to be fine. Knock on wood.
|
|
