|
|
Post by unclejohnaudio on Apr 25, 2017 14:22:01 GMT -5
I had some extra time and wanted to build a 3D model of the table on the AR8Pro. I have plans to incorporate some different clamping designs into the table. Plus I needed it in SolidWorks so that I can design some fixtures for cutting awkward angles on some parts I need to make. This design was measured with tape measure and might not be exact to the .001", but should be good enough. If you want any of the 3D file formats just let me know. |
|
jesse
New Member
Posts: 6 
|
Post by jesse on Apr 26, 2017 10:59:48 GMT -5
Thanks for posting this i will try to download the dxf tonight after work. I was planning on drawing up the table for similar reasons.
|
|
|
|
Post by pomeroypap on May 1, 2017 14:36:55 GMT -5
This is great! Thank you!
|
|
|
|
Post by smokediver576 on Aug 8, 2017 11:02:20 GMT -5
I had some extra time and wanted to build a 3D model of the table on the AR8Pro. I have plans to incorporate some different clamping designs into the table. Plus I needed it in SolidWorks so that I can design some fixtures for cutting awkward angles on some parts I need to make. This design was measured with tape measure and might not be exact to the .001", but should be good enough. If you want any of the 3D file formats just let me know. Any chance I could get this in a Step file? I'm using Fusion 360. Just purchased a full package AR8Pro today! Later, Awall |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 9, 2017 15:41:57 GMT -5
Fusion 360 will be fine with importing the DXF model, so will any CAD program as it's an old and well-supported file format.
|
|
|
|
Post by unclejohnaudio on Dec 2, 2017 21:16:17 GMT -5
I had some extra time and wanted to build a 3D model of the table on the AR8Pro. I have plans to incorporate some different clamping designs into the table. Plus I needed it in SolidWorks so that I can design some fixtures for cutting awkward angles on some parts I need to make. This design was measured with tape measure and might not be exact to the .001", but should be good enough. If you want any of the 3D file formats just let me know. Any chance I could get this in a Step file? I'm using Fusion 360. Just purchased a full package AR8Pro today! Later, AwallHere is the step file that I have saved. I havent checked these since i created them. |
|
