jack
New Member
Posts: 4
|
Post by jack on Nov 2, 2023 14:03:24 GMT -5
Our unit did not come with wrenches, I have been using unwieldly large crescent wrenches, cannot find replacement wrenches on the Axiom site. Anyone know what sizes the two chuck wrenches are for the AR16Elite?
|
|
|
Post by eagle55 on Nov 3, 2023 1:05:15 GMT -5
Have you contact customer service? That is where I would start, and tell that it didn’t come with wrenches. Given that it is a spindle, Im pretty sure it is supposed to. Now if its past the warranty, I can’t answer if they would be free, but I suspect they may be. If not I’m sure they would sell them to you. It may not be on the website, but then a lot of the parts wouldn’t be. They are extremely good and supportive of their products from what I have seen and experienced first hand.
|
|
jack
New Member
Posts: 4
|
Post by jack on Nov 3, 2023 13:33:10 GMT -5
Thank you for the reply. Our machine sat in storage for a year before I arrive, then sat for another 9 months before being used, so I believe it is out of warrantee. The 1/4" collet was missing too and it was a chore to deal with the company to receive another one. Can anyone answer my original question?
|
|
|
Post by eagle55 on Nov 3, 2023 13:41:45 GMT -5
Even with the delay in getting it going, I think you would be surprised at the level of support that they provide. Mine sit for 2 1/2 years because I didn't have time to "get my mind around learning the difference from my old Shark HD machine. I think there was a post recently where someone had bought a set of wrenches. You might do a search on old posts and see if you can find it. Again, I am pretty sure they will sell you parts(if not give them to you because they were missing)
|
|
|
Post by joeblow on Nov 3, 2023 15:24:44 GMT -5
Anyone know what sizes the two chuck wrenches are for the AR16Elite? I have the AR6 Pro and it looks we both have the same spindle. My wrenches measure 21mm and 30mm. I see the 30mm is readily available as an ER20 collet nut wrench on various websites. I’m sure you can easily find a 21mm wrench for the spindle itself.
|
|
trex
New Member
Posts: 1
|
Post by trex on Nov 3, 2023 15:34:05 GMT -5
|
|
|
Post by savannahdan on Nov 5, 2023 11:42:19 GMT -5
Here's an excellent source for collets, collet nuts and spanners wrenches. Also, their bits are choice. I plan to put in an order shortly for replacement collets and collet nuts. www.precisebits.com/
|
|