rowan
New Member
Posts: 2
|
Post by rowan on Jun 9, 2023 16:40:51 GMT -5
Hi guys I’m really new to this stuff. I just finished my second 3d job and felt it was time to install the laser that’s been collecting dust since I bought it. I didn’t have any issues until I popped the computer box open. Now I do see the instruction difference for the elite but my elite doesn’t look like this inside. If anyone has been through the his please help. Thanks lots
|
|
|
Post by gerry on Jun 9, 2023 21:57:10 GMT -5
Is your machine older or newer? The web site has up-to-date manuals.
|
|
rowan
New Member
Posts: 2
|
Post by rowan on Jun 10, 2023 12:41:45 GMT -5
It’s newer just got it a few months ago. I did get it all hooked up and got to the part of how to set my zero and I realize that my spindle sets too low for me to get the laser close enough to the wood. Can I just loosen the 4 screws holding the spindle on front of the machine and raise the spindle and tighten it back up? Will that throw off anything? Thanks a lot for any help and for the reply I got.
|
|