savantpcs
New Member
Always learning, always training
Posts: 23
|
Post by savantpcs on Mar 5, 2023 20:46:45 GMT -5
I have been seriously thinking about fixture plates for doing mixed part machining. Long story short is this: Has anyone come up with a solution or does the RichAuto control board even support using a probe that can probe the x and y axis' of the part or even probe the inside of a milled circle? Basically something like this: CNC Edge FinderAnd if the RichAuto DSP controller doesn't support it is there another option or does that leave the realm of Axiom and require 3rd party modification?
|
|
|
Post by Gary Campbell on Mar 5, 2023 21:21:48 GMT -5
There are numerous probing options with the Centroid Acorn controller. There are also a large number of 3rd party probing enhancements with Swissi's probing app (plug in)
|
|
savantpcs
New Member
Always learning, always training
Posts: 23
|
Post by savantpcs on Mar 5, 2023 21:26:04 GMT -5
Does that require changing out the controller on my AR6 or? Could you perhaps expand on what you mean?
|
|
|
Post by Gary Campbell on Mar 6, 2023 8:47:44 GMT -5
Yes it would require swapping out your controller to one that uses a PC. I no longer do stepper versions, only servos, but there may be someone that does steppers. There are also a number of AXIOM guys that have done the swap themselves and have documented it on the Centroid Acorn Support Forum.
|
|