|
|
Post by adam058 on Jan 24, 2023 18:45:21 GMT -5
I was cutting on my ar8 pro v5 and mistakenly set the z zero to the top of table instead of top of stock. So the spindle plunged straight down into the hdpe stock and stopped, and the machine spindle speed screen and the controller screen went out.
I've restarted the machine and unplugged it for 15 minutes and tried starting it back up but only the switch lights up.
Any suggestions?
|
|
toddd
New Member
Posts: 62
|
Post by toddd on Jan 25, 2023 1:08:33 GMT -5
I was cutting on my ar8 pro v5 and mistakenly set the z zero to the top of table instead of top of stock. So the spindle plunged straight down into the hdpe stock and stopped, and the machine spindle speed screen and the controller screen went out. I've restarted the machine and unplugged it for 15 minutes and tried starting it back up but only the switch lights up. Any suggestions? You probably blew one of the 4 internal fuses, open the case and replace fuse, unplug machine first |
|
|
|
Post by adam058 on Jan 25, 2023 17:55:04 GMT -5
That worked, thanks!
For anyone else with this issue, it's a 10A/250V fuse, 4 of them, in a clear holder that removes, located inside the cabinet on the bottom toward the back. I couldn't find anything about these in the manual
|
|
pedro
New Member
Posts: 84
|
Post by pedro on Feb 16, 2023 13:51:33 GMT -5
That worked, thanks! For anyone else with this issue, it's a 10A/250V fuse, 4 of them, in a clear holder that removes, located inside the cabinet on the bottom toward the back. I couldn't find anything about these in the manual can you share where you got the fuses, and which they are? Thought getting a few to have them ready in case something like this happens. tnxs |
|
