|
Post by rachel on Dec 17, 2022 12:54:30 GMT -5
We have the Jtech 2.8w laser and it turns on as soon as the file is started while it is moving into position and is burning that path until it gets to where it needs to be. It just started doing this. It was working properly before on the multiple test run pieces. Any ideas or suggestions on how to fix this?
|
|
|
Post by kokopelli2020 on Dec 17, 2022 14:06:46 GMT -5
Mine also did that. I went to Chad and Austin Buck for a solution. I do not remember exactly what they did or asked me to check but they were able to resolve it with a few simple steps. abuck@axiomtoolgroup.com
|
|
|
Post by gerry on Dec 18, 2022 12:22:11 GMT -5
That sounds like you're using the regular post processor, not the laser post processor. You should be using Axiom_HHC_Laser.pp.
|
|