Iconic 6 has no power

[tbyers]

My Iconic 6 is about a year old. While I was resurfacing a small piece of walnut, all the power on the machine shut down. I've checked the circuit break and it's good. I've also checked the fuse at the power connection on the tower and it isn't blown. Any thoughts?

[dadealeus]

Sept 29, 2022 14:48:17 GMT -5 tbyers said:

My Iconic 6 is about a year old. While I was resurfacing a small piece of walnut, all the power on the machine shut down. I've checked the circuit break and it's good. I've also checked the fuse at the power connection on the tower and it isn't blown. Any thoughts?

Did you smell any odd smells (burning electronics, etc.) when the shutdown occurred? Have you isolated it to the machine and not the outlet? (Like plugging in something else at that outlet - not sure if that machine is 110v or 220v, so might be easier said than done)

I would try isolating the power failure first. If you're sure that it's limited to the machine and not to the incoming power, then reach out to Axiom.

If you know what you're doing, you could try opening the case to have a look for damage on any of the components, but this may void a warranty or something, so do it at your own risk. Obviously, make sure the power is disconnected before you go looking.

Either way, you're likely going to need to reach out to Axiom for guidance or to source a replacement part if there was a component failure.

 

[tbyers]

Thanks for the suggestions. No odd smell and tried different outlets. Nothing. Waiting the hear from Axiom.

[toddd]

Sept 29, 2022 15:43:31 GMT -5 tbyers said:

Thanks for the suggestions. No odd smell and tried different outlets. Nothing. Waiting the hear from Axiom.

I have an AR8V5 that has fuses inside the case, they have blown occasionally when over doing it, they are user replaceable on mine

[tbyers]

Thanks for the information. Not sure there are any internal fuses on the Iconic 6. Haven't been able to find a diagram. Does anyone know? Still waiting for Axiom to respond to my request for help.

[tbyers]

Got it! The 10 amp fuse inside the case blew. Thanks for the advice and the info from the guys at Axiom.

UPDATE: Fuses are available at Lowes. Five fuses for under $4.

[Bob]

Thank you for the update. This is a big help for others in the future.

[jgarciaa]

Sept 29, 2022 14:48:17 GMT -5 tbyers said:

My Iconic 6 is about a year old. While I was resurfacing a small piece of walnut, all the power on the machine shut down. I've checked the circuit break and it's good. I've also checked the fuse at the power connection on the tower and it isn't blown. Any thoughts?

Consider looking into the Monport laser as it's highly regarded for its user-friendly interface, high-quality performance, and affordability. Unfortunately, I can't access external websites like monportlaser.com/collections/co2-laser-engravers/products/monport-40w-lightburn-ready-12-x-8-co2-laser-engraver-cutter-with-fda-approval?sca_ref=5031521.ka374VZjm3 Regarding your Iconic 6 machine issue, despite the circuit breaker and fuse checks, a sudden power shutdown could still be caused by various factors such as electrical faults, overheating, or issues with internal components. It's advisable to contact the manufacturer's customer support for troubleshooting assistance or to arrange for professional inspection and repair if necessary.