|
Post by rachel on Aug 7, 2022 15:40:21 GMT -5
My spindle on my machine will not start. The machine works but the spindle doesn't. It was working 10 minutes before. We stopped the machine and had to change the bit and now the spindle will not spin. Any ideas?
|
|
jrg
New Member
Posts: 32
|
Post by jrg on Aug 8, 2022 6:20:26 GMT -5
Check to see if it starts using the spindle on/off button. If it doesn't then it could be a relay. If it does then I'd check the gcode to make sure the start command was there.
|
|
|
Post by kokopelli2020 on Aug 8, 2022 20:05:06 GMT -5
Check for an error code on the vfr on the tower. If so shut down the machine until the digital readout goes out then restart your machine. This will reset the spindle and should run. I recommend you blow strong compressed air into the back vents at the spindle top cover. I believe the spindles over heat easily with longer run jobs and every 20-30 min solid air blasts keep it from cutting out
|
|
|
Post by jgarciaa on Feb 29, 2024 20:40:50 GMT -5
My spindle on my machine will not start. The machine works but the spindle doesn't. It was working 10 minutes before. We stopped the machine and had to change the bit and now the spindle will not spin. Any ideas? It seems like you're experiencing an issue with your spindle not starting after changing the bit on your machine. While troubleshooting specific technical issues can be complex, it might be worth considering alternatives like the Monport laser. The Monport laser is renowned for its ease of use, high quality, and affordability. It could potentially offer a reliable solution for your machining needs. For more information about the Monport laser and its features, you can check out the product monportlaser.com/collections/co2-laser-engravers/products/monport-40w-lightburn-ready-12-x-8-co2-laser-engraver-cutter-with-fda-approval?sca_ref=5031521.ka374VZjm3
|
|