|
Post by wgmcreations on Mar 6, 2022 12:36:44 GMT -5
I have an Iconic 6. When it works...awesome. I had my control tower off, moved it just 15 inches to the right. No cords tight, no cuts no pinched wires. Just moved it under my table so I can reach it better. Now I keep blowing the Power Cord Fuse on the back of the tower (5mmx20mm 10 amp fast blow fuse - confirmed from Axiom Tech). I have not had any change in power feed. I had main feed from outlet 133v when I started using it new 3 months ago. Now I keep blowing these fuses (FYI these fuses are nowhere to be found in my area). Axiom sent me 2 and I ordered a box from Amizon). I have no clue what is going on. So yes...Please help. I am DIW. I guess I should have left well enough alone.
Well, the crew at AXIOM pulled me out of the pit. Thanks again guys for getting me in and fixed quick like. You guys are awesome!!!!!!
|
|
Neil
New Member
Posts: 41
|
Post by Neil on Mar 6, 2022 13:14:47 GMT -5
I would try the following.
Open the case and follow the wiring into the case. Check all connections are firm and tight. Moving such a short distance could have cause something in the case to have moved and shorting. Make sure that the case is earthed to the cord.
You don't say if it shorts when you turn it on, or when under load. You may be using the machine differently now, cutting deeper, faster, cutter speed may have accidentally been reduced causing more bit load. Sometimes we forget to consider the obvious.
Trying to be helpful.
|
|
Bob
Junior Member
Posts: 129
|
Post by Bob on Mar 6, 2022 14:03:08 GMT -5
Try moving it back to the original location. If the problem disappears, good, but I guess it still would not answer the main question...
|
|