|
Post by daveasan on Feb 8, 2022 20:25:13 GMT -5
I have a Pro 8 which has been operating just fine until today. I'm trying to cut a 17" circle on a 3/4' board. I sent everyting to 0, it responded to the puck and started the cut. It went down about half way through the board and locked up (would not proceed in any direction) to the point nothing I could do with the hand held controller would move the head or stop the moor from running. I had to shut off the computer to stop it. Turned it back on and O'd all, the puck worked, and system worked just fine until I got bac to the same point where it locked up again.
I raised the work piece and O'd everything again. This time the z axis did not drop down to start the cut. Is there a way to reset the z axis or what do you think is wrong.
|
|