Issues with New Iconic 6

[copper]

We just received our new Iconic 6 and when the program shuts down after its completed, the 20 amp breaker trips every time. We also tried another receptacle on a different breaker and it also tripped at shutdown. There is nothing else running on the same circuit . Per local code the receptacles in my shop must on a GFI breaker. I have never had this issue with any other power tolls in my shop.   I am running the Iconic on a heavy gauged extension cord.  

Any ideas? 

Thanks in advance 

Will

[bentley]

Jan 24, 2022 14:36:48 GMT -5 copper said:

We just received our new Iconic 6 and when the program shuts down after its completed, the 20 amp breaker trips every time. We also tried another receptacle on a different breaker and it also tripped at shutdown. There is nothing else running on the same circuit . Per local code the receptacles in my shop must on a GFI breaker. I have never had this issue with any other power tolls in my shop.   I am running the Iconic on a heavy gauged extension cord.  

Any ideas? 

Thanks in advance 

Will

Hi.  If I recall in the manual it says to avoid extension cords.  I had to at first and occasionally it would trip.  That was even with an extension cord my electrician buddy made for me.  I figure maybe at the end of the program everything is running at once.  Head goes up, x axis and y axis go back to home.  Maybe drawing a lot of juice at once.  Have you tried setting the unit so it stops where it finishes the program?  You can change that in the settings in the handheld.