Post by cncowner on Jan 22, 2022 14:14:37 GMT -5
Just adding this in here in case someone else like me searches it in the future.
The Axiom CNC does NOT like the cold! Yesterday was the first day I went out to my workshop when it was about 10 degrees the night before and the workshop was 27 degrees when I walked in.
Wow. The machine even in a basic jog motion (I didn't even attempt to run it fully) was loud as hell just trying to move around. I thought for sure I broke something.
I ran the heaters and came back a few hours later when it was 40+ and everything worked smooth as butter. Again, just for folks who might run into the same issue. I Googled it and came up with very little.
The Axiom CNC does NOT like the cold! Yesterday was the first day I went out to my workshop when it was about 10 degrees the night before and the workshop was 27 degrees when I walked in.
Wow. The machine even in a basic jog motion (I didn't even attempt to run it fully) was loud as hell just trying to move around. I thought for sure I broke something.
I ran the heaters and came back a few hours later when it was 40+ and everything worked smooth as butter. Again, just for folks who might run into the same issue. I Googled it and came up with very little.