|
|
Post by ChuckD on Oct 16, 2021 12:59:09 GMT -5
just installed the led for my ar8 and "nothing"? there is only one way to plug this thing in, so what could it be?
any ideas?
thanks for the help
|
|
|
|
Post by Chad on Oct 18, 2021 8:34:11 GMT -5
![]()  Depending upon which machine you have, there may be a dedicated connector....on. all current (new) machines, this 2-pin connector should be attached to the LED kit as seen in the picture attached: The red wire on the LED kit...should connect to 24V, while the black wire will be 0V (or Ground). Please make sure that its oriented correctly. *The locking tab on the 24V lead will fit into an unused location on the LED fitting. |
|
|
|
Post by ChuckD on Oct 19, 2021 9:46:37 GMT -5
The connector wires on my machine are not labeled as the picture shows
The connector, as pictured, is how I've connected mine
My machine wires are blue(hot) brown(neg)judging by the picture
they connect to the led
blue - red brown - black
I just took it apart and re-connected and get nothing?
|
|
