chipclark2000
New Member
Long time woodworker, furniture maker, new to CNC!
Posts: 20
|
Post by chipclark2000 on Sept 22, 2021 13:36:51 GMT -5
Hoping someone can figure out what's going on here. When I run the toolpath preview it runs fine, as it should. But when I run the texturing toolpath on the AR-8 Pro, it runs the profile toolpath. I ran the profile toolpath and it also cuts the profile. I deleted the toolpaths and recreated them, but got the same result. I'm pretty experienced with CNC, but I've never had this happen before. Any ideas? Thanks! chip Attachments:MOA.crv (1.46 MB)
|
|
|
Post by gerry on Sept 23, 2021 16:19:13 GMT -5
Are you saving it as 1 single file or two separate files? The single selected file must have SELECTED TOOLPATH checked.
|
|
chipclark2000
New Member
Long time woodworker, furniture maker, new to CNC!
Posts: 20
|
Post by chipclark2000 on Sept 24, 2021 18:05:27 GMT -5
Are you saving it as 1 single file or two separate files? The single selected file must have SELECTED TOOLPATH checked. Thanks Gerry! That was the problem.
|
|
|
Post by gerry on Sept 25, 2021 2:09:25 GMT -5
Glad to help...
|
|