Post by irishwoodworker on May 18, 2021 11:57:47 GMT -5
While attempting to fix my tool path feed rate problem from yesterday, I now seem to have done some kind of reset. Even when I choose Fast/continuous mode, the X and Y movement is at a painfully slow rate and after 'homing all' I cannot get the Z down to move down very far. Any clues as to what I screwed up?
Post by irishwoodworker on May 18, 2021 13:43:50 GMT -5
A note to and a call from both Brad and Chad at Axiom resulted in getting the reset file from them. Everything is now reset to standard settings. Great service from the folks at Westerville OH as usual.