AR8 pro right angle

[smallhead]

Hello dear axiom cnc users, i'm using axiom AR8 pro V5 uccnc model and AR8 pro V5 b18e dsp controller model.



In the case of uccnc, when the following sculptures are processed, the right angle does not come out,

-> The same result even if processed using my friend's equipment (AR8 pro uccnc)



On the other hand, if it was machined with dsp(b18e), it was possible to get an accurate right angle. (Of course use the same .mmg file as uccnc)



Please let me know what to do to get more precise results from uccnc.



Thank you.

[Chad]

The primary use of this forum will be for customers using RichAuto DSP controllers.

While the UCCNC machines may feature the Axiom label...its a case of the machine itself being produced by us, and what is essentially a dealer...specifying their own UCCNC controls.


Axiom Tool Group, covers North America and supplies only RichAuto DSP controls. We will not be able to provide any support on the UCCNC controls...you will need to reach out to the supplier that you had purchased the machine through.

The issue that you are experiencing could be as simple as bit deflection, resulting from climb versus conventional cutting...and bit setup (speeds etc.).


Alternatively, it could also be sure to the gantry and table not being perfectly square to one another.

This can be adjusted by loosening and moving certain components....


A simple test is often to cut a two squares out of the same material (maybe 6")...Mark each square with an arrow so you know how they are oriented on the machine...

Stack them on top of each other and the squares should match up exactly.

Then rotate one square 90 deg...it should match up exactly still. (minus any acceptable bit deflection).


If the rotated square do not line up well, the gantry may need to be adjusted.

*I would suggest using something like masonite or MDF....plywood tends to have a fuzzy edge in places which may make it look like its not matching well.