Spoil Board Surfacing Issue

[kconway]

I'm trying to surface a new AR6.  After I home the machine i set my X/Y zero at the home position.  Then lower the spindle and set Z on the spoil board.  When i run the internal spoil board routine, the machine goes all the way to +X and crashes/stalls the stepper.  Doesn't seem right so I immediately crash out of the job.  What's going on here?  I can't find an X axis position sensor so I'm assuming there is a software stop set?  My machine doesn't stop when moving +X and crashes at the hard stop.

Kev

[Kristy]

Hey, Kev,

It sounds like the position of your x proximity switch tab has moved and needs to be repositioned. This is the silver L-bracket mounted on your x-axis.
If it is colliding with the right gantry leg, this is a sign that the tab needs to move to the left.

This can be solved with a simple phone call with our support team. [phone].
The team will need to know if your machine is an Iconic AR6 or Pro AR6.