|
|
Post by gene35146 on May 3, 2021 17:17:59 GMT -5
I have an AR8 Pro which I have had for a few years. I normally set my project datum to bottom left. I had a need to do a center datum and was able to set xy home on the controller and cut the project. After it does a toolpath it automatically returns to the normal bottom left. Is there something on the key pad I can push to get it back to go to the xy home I set on the controller other than jogging x/y until they are at zero again? It has been a few years I may have set it to automatically go back to home maybe I need to disable that not sure, if so that means now I have to manually do it for 99% of my projects or keep flipping that automatically go home setting not sure if that is in Aspire or on the machine it has been so long.
|
|
|
|
Post by gerry on May 3, 2021 17:31:23 GMT -5
The yellow REF/OK button returns you to Origin (XY=0).
|
|
|
|
Post by gene35146 on May 14, 2021 13:30:23 GMT -5
Thanks. On mine it is the GREEN button on the bottom left that has ORIGIN/OK on it.
|
|
waynek
New Member
I am new to using my AXIOM Pro 5 AR-6 machine but not new to using a CNC router.
Posts: 2 
|
Post by waynek on Jul 11, 2021 8:38:45 GMT -5
Gerry I have the same question but I have the AXIOM Pro AR-6. My machine came with the Rich Auto Controller B18E. I would post a picture of my keypad but I don't know how?
WayneK
|
|
|
|
Post by gerry on Jul 11, 2021 14:58:21 GMT -5
 B18 Controller You MUST home your machine when you first turn it on. In fact, the screen comes up asking you to HOME XYZ. After HOME, it will move to XY Datum position. If you want to HOME, now use the ZRN (9) key. How to home your CNCSetting Multiple Origins |
|
