|
Post by justlearnin on Apr 4, 2021 8:16:45 GMT -5
Lately i have done some pocket cuts with a .125 end mill bit and a 7percent stepover but my pocket floor is smooth except around the edges. I tried changing the toolpath so that the profile cut was eliminated but that did not seem to help as it left irregular edges. any suggestions?
|
|
|
Post by joeblow on Apr 5, 2021 5:06:28 GMT -5
Best suggestion I can give is to at least post a picture highlighting the problem or better yet post your file and peeps here can have a look at the file and vector you are using.
I'm assuming, because I have no further info, that the vector you are using needs cleaning up with node editing.
|
|