djl
New Member
Posts: 16
|
Post by djl on Nov 4, 2020 17:49:08 GMT -5
Hi Everybody,
New to the Axion Ixonic 8 but have used Fusion for some time. When it comes to post processing I am using the RS274 PP. Works for metric files but not so good for Imperial files. For Imperial files a Feed rate of 100 in/min is interpreted as 100mm per min. Any suggestions for getting the correct Feed Rate when using Imperial files. Are there any other settings that the RS274 PP fails to convert to run correctly on the AutoRich controller? Open to all and any suggestions and helpful hints.
Thank you in advance.
Doug
|
|
djl
New Member
Posts: 16
|
Post by djl on Nov 5, 2020 21:29:03 GMT -5
Solved - set units in the PP
Doug
|
|