drdoor
New Member
I have been a wood door refinisher for 20 years. looking to do some side business or just play with
Posts: 13
|
Post by drdoor on Sept 7, 2020 9:22:50 GMT -5
I am trying to set my zero point for the piece I am running and I keep getting this error In short it says I need too switch from machine state to workpiece state. For the life of me I can't figure out what I am doing wrong . Anyone have a solution?
|
|
pieman
New Member
Retired USPS
Posts: 69
|
Post by pieman on Sept 7, 2020 9:41:57 GMT -5
I'm not sure about your controller, but on mine, I would have to hold the MENU button down and Press 1 to get back to the work state on the controller.
|
|
pieman
New Member
Retired USPS
Posts: 69
|
Post by pieman on Sept 7, 2020 10:22:31 GMT -5
I checked the downloaded manual for the Elite and it says the same for your controller. Page 44 in the trouble shooting section, 4th subject down.
|
|