lesad
New Member
Posts: 50
|
Post by lesad on Nov 13, 2019 20:01:07 GMT -5
I swear I take one step forward and two steps back with my machine. No ones fault but mine I have no time to use it so I cant remember things from one time to another. I tried running it tonight and it says y is out of soft limit does anyone have step by step directions for running this file? I have watched some you tubes but I don't see what I am doing wrong? Where do I put the home for this file? Is that It? Any help is appreciated.
|
|
|
Post by stevem on Nov 13, 2019 20:23:05 GMT -5
Out of soft limits means the project will cut out of the limit of your machine. Check your file and orientation and make sure the work piece is in the the limits of the machine.
|
|
lesad
New Member
Posts: 50
|
Post by lesad on Nov 13, 2019 20:27:45 GMT -5
The last file I cut on my machine I had to turn long ways but I am running the fly cut that came with the machine so would that effect it?
|
|
|
Post by stevem on Nov 13, 2019 20:37:12 GMT -5
Not really! The fly cut is simply for making sure your bed is completely level to the router or spindle. Look at the post I just entered in the other thred you asked about. I just entered a long explination. Steve
|
|
lesad
New Member
Posts: 50
|
Post by lesad on Nov 15, 2019 9:17:31 GMT -5
Someone at Axiom helped me out with this they are very helpful if you can call I just have a lot of obstacles with calling like I work until 430 and I cant get a signal in my workshop.lol Then Chad called me back last night and asked if I had all of my issues taken care of. They are an awesome company.
|
|