|
|
Post by gerry on Jun 25, 2019 23:56:18 GMT -5
Today I hit Run/Pause during a laser run, to check a clamp. It paused, but the laser did not turn off. Is there a method to pause a run AND turn off the laser?
|
|
|
|
Post by Axiom Tool Group on Jun 27, 2019 9:12:18 GMT -5
The pause operation does not typically break the spindle commands...otherwise it would deactivate the spindle during a normal CNC operation.
If this were gcode related, I believe we could find a way to correct this. However with it being a controller operation it may require a firmware adjustment which would then effect the spindle.
You may try pausing during shuttle moves when the laser is inactive....to be honest, I've not tried that myself so I'm not sure if it will work.
|
|
