|
Post by wateague on Dec 19, 2018 17:01:15 GMT -5
I have the Axiom Precision AR8 Elite, With Hurst Controller . I successfully ran my 4th axis but can't get it to run in normal mode after removing the 4th axis. After selecting file and pressing Left Arrow Key my Z axis just moves slowly down until I hit Emergency Stop... I tried 2 different SD cards. Pulled up a saved Post Processor file and resaved a file and I wonder about the names of all the Post Processors that I have. It has been about a year since I have used a regular 2D file because I played with the Laser and 4th Axis. I installed and tried to operate the 4th Axis before finding out that it couldn't work, after a couple weeks I got the Parameters to change in the Controller. Since then I have not used the machine for regular 2D or 3D router work... I have very few hours on this machine compared to my other CNC because the other machine is so much easier for me to operate. I suspect that my' USER Setting' page is set wrong , I tried a couple other settings. My Homing XYZ: 0, Homing AB:0, Read more: axiomprecision.proboards.com/post/new/867#ixzz5aAUTD5u0
|
|