zaxis4
Junior Member
Posts: 162 
|
Post by zaxis4 on Jan 9, 2024 18:23:32 GMT -5
|
|
|
|
Post by aluomala on Jan 10, 2024 15:17:37 GMT -5
In the file you provide, there are no toolpaths, so we can't really give any input.
|
|
zaxis4
Junior Member
Posts: 162
|
Post by zaxis4 on Jan 10, 2024 18:40:29 GMT -5
File is too large to upload with toolpaths already run. The tools are chosen so I thought one could run the simulation on their computer to check it out?  all it needs is calculate to see them. 5Mb upload is not much room for upload. |
|
|
|
Post by aluomala on Jan 10, 2024 19:02:30 GMT -5
File is too large to upload with toolpaths already run. The tools are chosen so I thought one could run the simulation on their computer to check it out? all it needs is calculate to see them. 5Mb upload is not much room for upload. You can use things like GoogleDrive, DropBox, etc to get around the 5MB limit. I'm not sure why having the toolpaths included would increase the file size any appreciable amount. The largest part of that file is the STL model. The toolpath information (which bits your using, which strategies you are employing (particularly with the finishing toolpath(s)) is critical. I have a few suggestions, based on the way I would approach it, but seeing what you have already worked on would be much easier to help you with. Allan |
|
zaxis4
Junior Member
Posts: 162
|
Post by zaxis4 on Jan 10, 2024 20:43:45 GMT -5
It’s over 8. I already tried that. Thanks for at least replying though. I’ll try Vetric. They are always good about this sort of thing. I thought the axiom users would be easier and faster.
|
|
all it needs is calculate to see them. 5Mb upload is not much room for upload.