V-Carve toolpaths are ramping and are not supposed too.

[bsoaper]

I have created a number of v-carve tool paths on my job and all of them are ramping down like a fluting toolpath when no ramp is defined.  The preview of the toolpaths show correctly in Vectric V-Carve Pro.  I have tried rebooting the machine, recreating the toolpaths and a few other things but the controller or machine continues to ramp the at the start of each cut.

[jvask]

In the V-carve toolpath selection:are you selecting the v-bit under (Tool) and not under (Use Clearance Tool)?