|
Post by gene35146 on Feb 5, 2022 16:13:03 GMT -5
As you can see from a previous post I added some registration pins. I put a single pin in the front left corner then used the pattern to send a group up Y and across X and drilled them. When I put my trusty Woodpecker square across it the x pins are all in line and the y pins are all in line but they are not 90 degrees to one another. That gap measures about 1/16 of an inch? Not sure what could cause it or how to fix it. It is fine for about 12 to 18 inchs then it starts to drift on both the x and y axis.
|
|
pedro
New Member
Posts: 84
|
Post by pedro on Mar 7, 2022 20:19:52 GMT -5
Just help me understand...did you drill the holes with the CNC? In that case, it should match...
|
|