|
Post by mrnewman on Jan 17, 2022 22:13:20 GMT -5
I would like to try a 1/16 dia up cut spiral bit. I see a couple of Amana ones (spectra vs not) and a few import ones on amazon that are half the price. I really want to try one but the actual written reviews for them are not quite as good as I would normally like to see so I am struggling to spend $40+ just to have it break on the first run. I'm sure that I will have to dial down feed and increases passes to minimize stress but wondering if anyone has had luck with one and what feeds you are using?
|
|
|
Post by germanguitars on Jan 18, 2022 10:21:25 GMT -5
|
|
savantpcs
New Member
Always learning, always training
Posts: 23
|
Post by savantpcs on Jun 5, 2023 19:22:58 GMT -5
I would like to try a 1/16 dia up cut spiral bit. I see a couple of Amana ones (spectra vs not) and a few import ones on amazon that are half the price. I really want to try one but the actual written reviews for them are not quite as good as I would normally like to see so I am struggling to spend $40+ just to have it break on the first run. I'm sure that I will have to dial down feed and increases passes to minimize stress but wondering if anyone has had luck with one and what feeds you are using? Hey boss what material are you going to be cutting with it? I have used quite a few Amana 1/16th end mills with a lot of success but the journey to success left my pockets hurting at times.
|
|