|
|
Post by rexrex101 on Nov 28, 2021 1:03:49 GMT -5
I received a replacement Rich Auto hand held unit and had to tell it what the table size is. After that I restarted the CNC and when asked to Home All I said yes and it moved to the left front as it should. The reading was not 0.0 for X and Y. Is there an initial setup procedure so I can make sure everything is configured properly? I have the Axiom I2R-8
Thank you!
Rob
|
|
|
|
Post by gerry on Nov 28, 2021 1:06:43 GMT -5
Call Chad. The should be able to send you a config file for your specific CNC model.
|
|
|
|
Post by joeblow on Nov 28, 2021 5:45:39 GMT -5
Refer to Page 26 of your manual. I suspect all is well and you are seeing the Origin displayed for whatever coordinate work state you are in. There are 9 coordinate work states each with their own user defined Origin. Once your machine has homed to the lower left corner you will see the Origin for whichever coordinate work state you are in (1X?, 1Y?, 1Z?) displayed in relation to the Home Origin (X0, Y0, Z0). Next time you Home your machine, press Menu+0 and the following should display....... AX0, AY0, AZ0. This is the Machine Coordinate State and should display 0's. There is no user input here and you should then press Menu+(1-9) to get back to a work state. This is a very handy feature btw.
Giving Axiom support a call is always a good idea as they are the only company I know that actually has a Human Being (with a brain nonetheless) answer the phone.
|
|
