|
|
Post by stevep on Jun 28, 2021 16:22:24 GMT -5
Should the 0,0 location be in the center of my machine?
Chad, you recently reprogramed my controller and now it does not return to center when start up? Can I set the 0,0 point from my end?
Thanks
Steve
|
|
|
|
Post by gerry on Jun 28, 2021 19:36:39 GMT -5
Home (0,0) is near left.
|
|
|
|
Post by stevep on Jun 29, 2021 12:33:01 GMT -5
Mine is there now but before my controller was reprogramed it was centered on my table. Aspire defaults there when starting a project. I can redo all my projects and make them use 170,317 in lieu of 0,0. This seems like way to much work and am hoping not to go this route. Chad is there a way I can reset this on my end? Thanks for your help. |
|
|
|
Post by Chad on Jun 29, 2021 13:58:16 GMT -5
The HOME location (which is simply a mechanical reference point) will always be in the front corner.
Your working origin...or 0,0 location for the X and Y axes, will literally be wherever you place it.
Ideally, you will be selecting one of the 4-corners of your material or the center location in the design software.
Then at the machine (after the HOME has been completed)..you will jog the bit to that location and press the XY-0 button.
*The origin at the machine must match the origin that is selected in the design software.
|
|
|
|
Post by stevep on Jun 30, 2021 8:37:01 GMT -5
Thank you Chad.
|
|
