|
Post by emilyc on Apr 22, 2020 22:32:54 GMT -5
Was running a file tonight and randomly during the toolpath the z plunges significantly deeper. I was running a 1/4” EM at 100 IPM with a DOC of 0.125”. The rest of the file was fine. Switched bits to a 1/8” EM and had no issues. However went to run the house third tool path with the same 1/8” bit and it plunged significantly deeper than what was programmed then proceeded to run a line across the face of my workpiece. Anybody have any ideas?
|
|
|
Post by cncworksdan on Apr 23, 2020 20:19:15 GMT -5
Emilyc More info may be needed to rule out program file problems. Some quick checks to eliminate simple problems : 1) speed set too excessive could contribute to loosening spindle nut allowing the tool to slip down. 2)the spindle collet could be clogged with fine chips not allowing it to hold the tools properly. I hope this helps because ruined projects can be very frustrating.
|
|