clay
New Member
Posts: 3
|
Post by clay on May 20, 2019 16:28:58 GMT -5
I just got a axiom pro 6
I have not tried to run any tool paths yet, just pushing buttons on the pendant and it seems like the big red stop button on the white box/controller does nothing
i am guess either my red emergency button is broke or it does nothing to stop the pendant and is only to stop tool paths ?
my axiom starts up even if the red emergency button is pressed in, is this normal ?
|
|
clay
New Member
Posts: 3
|
Post by clay on May 20, 2019 19:37:36 GMT -5
i created a .mmg tool path and let it run for a few minutes just watching the machine move by its self without me touching the pendant and then i pushed in the big red emergency button and nothing happened the emergency button did not stop anything
other than the emergency button doing absolutely the axiom pro seems to be working like it should
is there something i am not understanding about the emergency button do i need to set the machine up to use the emergency button or do i just have a faulty emergency button ?
i guess if i have a faulty emergency it does not matter there is the on off switch and 220 outlet is just as close as the emergency button
i just wish i knew for sure if the emergency button is faulty or if i am missing something here
|
|
|
Post by Axiom Tool Group on May 21, 2019 10:00:41 GMT -5
The Emergency button, should stop all operation and cut power to the entire machine. It also works as a lock-out device to prevent anyone from using it. However, its a tow part switch...the outer portion and the inner portion which the electrical wires are attached to. These two halves simply click together...insert the two pieces together and rotate the inside portion clockwise to click... IMG_8896.HEIC (1.03 MB)
|
|
clay
New Member
Posts: 3
|
Post by clay on May 21, 2019 16:02:16 GMT -5
it is a great machine and there is lots of support for it you can see .HEIC files with live heic to jpg at heictojpg.com below are pics of my 1st try at wood carving, 1st time i ever used a cnc to cut anything, the 1st tool path i made the step over percent to hi or something i will figure it out still not bad for my very 1st attempt, 2nd tool path with smaller finishing bit worked perfectly i wonder if i did a whole carving with just the smaller finishing bit with 1 tool path if that would be to much work for the smaller finishing bit
|
|