Post by designccmb on Sept 24, 2018 6:45:35 GMT -5
Hi, In the user manual, it is stated that the machine can rapid travel at 5000 mm/min and i am pretty sure X and Y could do it but the Z axis skips steps when setting rapid at more than 2500 mm/min. Is there a way to have the Z axis rapid travel slower than X and Y?
So far, this is the only issue. The machine is rock solid!
which machine and which software are you using? Most software is fully capable of setting the z-axis feed rate (plunge) as well as establishing different patterns of entry into the material. This will be something you do in the software that builds the G-code for the machine but it's certainly possible (and advisable).