|
Post by moodytx on Jun 21, 2018 17:39:29 GMT -5
Is/has anyone used the Vectric Photo VCarve software (either licensed or trial) with their Axiom ? I'm wonder what Post Processor was used? Bob <UPDATE> No sooner did I post this question then i looked on the Vectric site and found basically the same question and a response from Chad at Axiom .. www.axiomprecision.com/postThe post processor is on the Axiom site .. </UPDATE>
|
|
|
Post by uzumati on Jun 22, 2018 9:07:10 GMT -5
Yes have to get the PVC post, I have been playing with it but have only done a couple of trial pics with it. It takes some playing around with depth, step over (it can go lower than the slider just input numbers), and tool selection but I am starting to get a feel for it, if I get time next week I am going to do a hi res photo of my dog.
Ps. A vacuum hold down system works really well for pvc projects unless you calculate board size for some margin for the clamps.
|
|