hthr
New Member
Posts: 2
|
Post by hthr on Apr 6, 2018 8:49:31 GMT -5
Two days ago I did a lot of cutting and everything seemed fine. At one point when I turned on the machine, it got stuck at 15% on the startup screen. I thought maybe it didn't like that I had put in the thumb drive during the startup process, so I turned it off and on again, and it was fine. Now today Every time I turn on the machine, it gets stuck at 15%. Any ideas? Attachments:
|
|
|
Post by stevem on Apr 6, 2018 9:26:47 GMT -5
First thing to check is to unplug the cable from the control box and the controller and then reinsert them. Make sure the metal connector on the cable it connected to the control box and the black end connected to the pendant. Also check for any pins on the cable that may possibly be bent before re installing them. Then try turning the machine back on and see if it works correctly. If that doesn't help, a call to Chad at Axiom would be the next thing to do. Good luck and I hope it works for you!
|
|
hthr
New Member
Posts: 2
|
Post by hthr on Apr 9, 2018 13:15:23 GMT -5
Yup, Chad sent me a System Update file and it fixed the issue.
|
|
|
Post by stevem on Apr 9, 2018 13:35:34 GMT -5
Glad it didn't take long till you were back up and running!!
|
|