|
Post by garylyb on Mar 30, 2018 22:17:19 GMT -5
I'm getting this assert when trying to cut the toolpath "profile bottom" in the attached file It seems like it's a calculation error in the hhc. Any idea what is happening? 8x20 rounded-120 v bit.crv (93.5 KB) Profile bottom.mmg (5.94 KB)
|
|
|
Post by garylyb on Mar 30, 2018 23:35:04 GMT -5
Well, I changed the bottom toolpath from conventional to climb, and it worked.
That must be some kind of calculation error on line 107
|
|
|
Post by Axiom Tool Group on Apr 16, 2018 11:15:10 GMT -5
There is a work around of sorts for these errors...which appear to be related to how the GCode was created.
Since this locks up the controller, requiring a hard reboot. When you turn the machine back on, perform your HOME operaiton, then you will get a message saying that there was a power failure during the last machine operation.
Press OK to resume...afterwards, you will be shown the line of g-code where the break occurred. Use the X=/- buttons to move forward 3 lines.
Then press OK to resume.
This has shown to move the machine beyond the error in code.
|
|