|
Post by bigduke6 on Feb 3, 2018 11:35:31 GMT -5
I have been changing the feed rate in the tool selection menu. I have had a couple jobs go bad ( loose zero ) because the rate was to fast. It just didn't seem that the speed was changing after my adjustment. After a little research here, I found an option in the controller menu in the G code set up for F read, but it was already set properly. I've dug through the manual but must be missing something. Would appreciate any advice. Thank you
|
|
|
Post by bigduke6 on Feb 5, 2018 11:10:58 GMT -5
Answering for future reference. When I updated to VCarve pro 9 my post processor became Richauto 11. I switched back to the axiom processor and problem solved. Thanks Chad.
|
|