Post by C&C Woodsmith on Aug 8, 2017 9:54:31 GMT -5
My machine has stopped in the middle of the run twice and ruined a couple workpieces both after completing a successful previous run, with the same file, and homing all axes between.
I haven't been in the room when it happens so I'm not sure what's happening. But afterwards the spindle is stuck. I can loosen it by hand and it seems to run again, but it makes a sound that scares me.
Is this concerning, or is it normalI can also see the coolant circulating through the tubes, so it's not a coolant problem.
*************************************
Edit, Chad from Axiom contacted me and is taking care of it. Great customer service.
Thanks, Chris
I haven't been in the room when it happens so I'm not sure what's happening. But afterwards the spindle is stuck. I can loosen it by hand and it seems to run again, but it makes a sound that scares me.
Is this concerning, or is it normalI can also see the coolant circulating through the tubes, so it's not a coolant problem.
*************************************
Edit, Chad from Axiom contacted me and is taking care of it. Great customer service.
Thanks, Chris