|
Post by C&J on Jun 22, 2020 12:04:08 GMT -5
Yesterday and today, we have had a problem with our Z axis. When we turned the machine on yesterday and homed 'all axis' the 1/8 inch ball nose rose just enough to pair clear the clamp. Today i homed it before i placed the clamps but the same bit wouldnt have cleared my clamps. I can lower my Z axis, but not raise it any more that where it is sitting. Any ideas or suggestions? **Axion Icionic with AutoRich Handheld controller**
|
|
jrg
New Member
Posts: 32
|
Post by jrg on Jun 29, 2020 7:00:25 GMT -5
Yesterday and today, we have had a problem with our Z axis. When we turned the machine on yesterday and homed 'all axis' the 1/8 inch ball nose rose just enough to pair clear the clamp. Today i homed it before i placed the clamps but the same bit wouldnt have cleared my clamps. I can lower my Z axis, but not raise it any more that where it is sitting. Any ideas or suggestions? **Axion Icionic with AutoRich Handheld controller** Check to make sure the coupler is tight. The set screw may have come loose.
|
|