|
Post by cavguy on May 31, 2020 20:21:21 GMT -5
Hi,
My Pro was running fine and suddenly took an unscheduled plunge through the workpiece. It kept working and took another and started to move over the X-axis. Before I could reach it to turn it off, it shut off. When I tried to turn it on, nothing happened. Then I noticed the red breaker was in the out position. I pressed it and it went in and the green power light around the switch came on. Nothing on the controller, no power to the cutter and the light accessory did not come on. I tried cycling the switch several times and even waited about 30 minutes to see if it overheated and would cycle back on. The motor was the least bit warm when it first happened but not at all hot. Any ideas?
|
|
|
Post by S on Jun 17, 2020 17:44:37 GMT -5
Hi there, This exact same thing JUST happened to me and I came across your question as I was frantically searching for an answer. I removed the cover from the box and saw that there are fuse boxes on the lower left side inside the box. I discovered with the machine plugged in and the switch powered on, that there is a little orange light that illuminated one of the fuse locations. I shut off the machine and unplugged it, then removed the fuse cover and sure enough the fuse is blown. I haven't replaced it yet, but I'd bet the farm that it will power up normally once it is replaced. For me, it was the second from the left that blew and it was a 10A250V fuse. Hope this helps!
|
|
|
Post by cavguy on Jun 21, 2020 19:51:47 GMT -5
I called Axiom and got the same answer. I replaced the fuse and it worked fine. Turns out I had a programming error in my work on Vetric that caused the plunge and stalled the motor, blowing the fuse. Works great, thanks.
|
|