|
Post by todddineen on Jan 30, 2020 14:35:25 GMT -5
I own Vcarve pro, there are some cut files I would like to mill that were created in Aspire, and saved as crv3d files. Is it possible to convert these files to crv files so I can load them?
|
|
|
Post by redwood on Jan 30, 2020 14:50:57 GMT -5
I don't believe that you can convert the Aspire files without Aspire. I have Aspire and it appears that I can save files with a crv extension.
|
|
|
Post by Mezalick on Jan 30, 2020 15:55:22 GMT -5
I don't believe that you can convert the Aspire files without Aspire. I have Aspire and it appears that I can save files with a crv extension. Unfortunately, items not associated with VCarve are deleted before saving the file from Aspire This includes any 3-D components. Michael
|
|
|
Post by gerry on Jan 30, 2020 16:11:08 GMT -5
And.... if you do convert to crv, I would be very, very careful that the output matches the original. I've corrected some crv files in Aspire then have to carefully check against original when re-saving as crv. This is mostly anecdotal, as I don't remember specifics, but I've been surprised at some of the missing elements in the crv save.
|
|