|
Post by reinfly on Dec 31, 2019 10:47:18 GMT -5
Hello,
After I set my z axis to start and the arm raises and I then run my job. The arm does not drop down to the z axis start position. Can anyone help me troubleshoot this problem please.
Thanks.
|
|
johnb
Full Member
New owner @ March 2019, AR16 Elite, Aspire, 4th Axis & Laser
Posts: 326
|
Post by johnb on Dec 31, 2019 17:53:05 GMT -5
You asked this same question on a different thread...and then apparently solved your issue by saving the post processor file with the correct extension. Can we assume that you don't need further help with this issue?
|
|
|
Post by reinfly on Jan 1, 2020 9:35:53 GMT -5
You can figure it out because you are such a brilliant individual. But lets assume for now you may have some challenges in this area I will explain.
I posted the problem and when searching for the thread I did not find it. It looked for it in the wrong section. I thought I didn't send it hence the reason the second post.
I hope you didn't get too disturbed by this incident. Blessings.
|
|
|
Post by gerry on Jan 1, 2020 13:42:50 GMT -5
You can figure it out because you are such a brilliant individual. But lets assume for now you may have some challenges in this area I will explain. I posted the problem and when searching for the thread I did not find it. It looked for it in the wrong section. I thought I didn't send it hence the reason the second post. I hope you didn't get too disturbed by this incident. Blessings. ...and people wonder why there are less and less of us willing to answer questions around here.
|
|
|
Post by stevem on Jan 1, 2020 15:53:37 GMT -5
gerry: I was thinking the same thing! reinfly, you really need to lighten up! johnb was only trying to assist you.
|
|