|
Post by Roland on Sept 20, 2018 13:49:04 GMT -5
I though I would share the Router Wrench holder I made. I found going in to the drawer every bit change to get the wrenches and extra step and a bit repetitive, So I created a Wrench holder. The wrenches very handy and located just below the Home position of the machine. The holder does not get in the way of the accessing the Draws below. I cut out the profile and made a pocket in it using the CNC machine then glued on a few short pieces of wood to each side and the front. I mounted it with a small down angle by cutting an angle on the back edge of the holder then glued it to a board that lays on the bar below the CNC machine. I added a short board to the bottom back of that piece that would just fit down around the bar under the CNC machine. I then used the two-sided foam tape. I am including the simple Aspire .crv3d file and saved it as a .crv file that should work with VCarve. router wrench holder.crv3d (232 KB) router wrench holder.crv (226.5 KB)
|
|
|
Post by uzumati on Sept 20, 2018 14:05:16 GMT -5
Had the same thought but didn’t think to make a holder, just attached a harbor freight magnetic bar to the underside on the frame. Always right there when you need them, might have to go back and make some like yours,
|
|
|
Post by arsystems on Sept 21, 2018 8:18:48 GMT -5
That's a cool idea, where did you get the little blue bit storage holders? I can't seem to find them.
|
|
|
Post by arsystems on Sept 21, 2018 9:06:56 GMT -5
disregard, I now see your other post.
|
|
|
Post by bushpigdesign on Sept 22, 2018 6:35:04 GMT -5
That’s pretty cool, I think I’m going to make one myself. Cheers...
|
|
|
Post by jaybates86 on Oct 29, 2018 6:58:23 GMT -5
Just wanted to say thanks for the idea. The idea of using zip ties to hold the controller cord up over the drawers is so simple and exactly what I needed. I use the controller on the left side as well. It's the simple things that are often overlooked.
|
|