|
|
Post by germanguitars on Dec 25, 2016 20:15:21 GMT -5
I thought this CAD version of the tabletop might come in handy in the future for placing objects and planning out custom vacuum zones. If anyone wants this file for themselves I can post it up. (no guarantees on accuracy - the width is accurate and the MDF placements are true for my machine, but obviously the +Y and -Y perimeter edges might be different on your machine.) Also cut a crisp centerline and an inset boundary for lining up objects.   |
|
|
|
Post by chester442 on Dec 26, 2016 16:23:50 GMT -5
Nice work! Looks great!
|
|
|
|
Post by westwood on Dec 26, 2016 21:00:13 GMT -5
please post in a file so we can change to inches
|
|
|
|
Post by germanguitars on Dec 27, 2016 7:58:56 GMT -5
DXF and 3DM files are slightly over the 1MB limit - can't upload. If you email me I can send you a Google Drive link to a copy of those files. IGS and DWG attached if those are useful to you. 3DM file has RhinoCAM machine operations included. Attachments:TableSurface.igs (848.74 KB)
TableSurface.dwg (95.56 KB)
|
|
|
|
Post by trung999 on Dec 31, 2016 12:53:19 GMT -5
DXF and 3DM files are slightly over the 1MB limit - can't upload. If you email me I can send you a Google Drive link to a copy of those files. IGS and DWG attached if those are useful to you. 3DM file has RhinoCAM machine operations included. Just PM'ed for .3dm file. I have an AR8 and use MadCAM but can modify. Thanks. |
|
ajl79
New Member
Posts: 12 
|
Post by ajl79 on Feb 4, 2017 21:48:33 GMT -5
has anyone ran the files above and had good success? I want to run this on my spoil board.....just wanted to get feedback if anyone else has had luck running it and the measurements lining up.
|
|
|
|
Post by trung999 on Feb 5, 2017 2:22:38 GMT -5
has anyone ran the files above and had good success? I want to run this on my spoil board.....just wanted to get feedback if anyone else has had luck running it and the measurements lining up. I was only interested in the CAD file (.3dm). My table already had alignment carvings. The CAD is very nice and I can make use of that but then I design with Rhino. You can ask for the dxf file, import that into Vectric and see if you can make use of it (not sure it's worth it from the attached result). I don't think Vectric can do anything with an .igs file.   |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Feb 5, 2017 11:02:03 GMT -5
You could just use Vectric software and draw a rectangle then run a Pocket Toolpath and adjust the stepover to whatever you want. It will figure everything out for you and it's very simple project. Make sure you check Ramp Plunge Moves.
|
|
ramin
New Member
Posts: 1
|
Post by ramin on Jul 18, 2017 10:53:43 GMT -5
hi. thanks for the nice job. Could I have the cad files please? thanks |
|
