Tore
New Member
Posts: 4
|
Post by Tore on Oct 24, 2019 19:22:31 GMT -5
I picked up my I2R-6 from the warehouse last week. It took a few days before I had it set up in my basement. This is the first 3d carve I have done with this new machine. I'm pretty happy with the results. Padauk, 14.75" long and 10.5" wide. Roughing done with a 0.25" end mill. Finishing done with R0.5mm tbn and the small letters with a R0.25mm tbn. Just have the cutting-out left to do. Attachments:
|
|
zaxis4
Junior Member
Posts: 162
|
Post by zaxis4 on Oct 24, 2019 21:41:23 GMT -5
So what was the carve time. Just curious....
|
|
Tore
New Member
Posts: 4
|
Post by Tore on Oct 25, 2019 8:13:55 GMT -5
One correction. The roughing tool was a 0.125" end mill and not a 0.250" as stated above. The roughing time took ~4h 20min and the finishing ~9h 45min.
|
|